A swamp cooler is essentially a large fan with water-moistened pads in front of it. The fan draws warm outside air through the pads and blows the now-cooled air throughout the house. The pads can be made of wood shavings - wood from aspen trees is a traditional choice - or other materials that absorb and hold moisture while resisting mildew. Aspen wood pads, also called excelsior, need to be replaced every season or two, and generally cost $20 to $40 for a set.
Small distribution lines supply water to the top of the pads. Water soaks the pads and, thanks to gravity, trickles through them to collect in a sump at the bottom of the swamp cooler. A small water pump circulates the collected water back to the top of the pads. Then the process begins over again.
Since water is continually lost through evaporation, a float valve - much like the one that controls the water in a toilet tank - adds water to the sump when the level gets low. Under normal conditions, a swamp cooler can use between 3 to 15 gallons of water a day.
A large fan draws air through the pads, where evaporation drops the temperature approximately 20 degrees. The fan then blows this cooled air into the house. Small swamp coolers can be installed in a window, blowing cooled air directly into a room. Larger units can blow air into a central location, or the air can travel through ductwork to individual rooms.
Normal air conditioning is a closed system, taking air from inside a house and recycling it. For air conditioning to function properly, doors and windows should be closed. A swamp cooler, however, takes air from outside the house. For an evaporative cooler to work properly, the cooled outside air must be allowed to escape. By choosing which doors or windows in your home you leave open, you can to help direct the flow of cooled air to areas where it is needed.
Adobe Air Swamp Coolers offer a full line of finely crafted swamp cooler for your garage or warehouse.
- wood from aspen trees is a traditional choice - or other materials that absorb and hold moisture while resisting mildew. Aspen wood pads, also called excelsior, need to be replaced every season or two, and generally cost $20 to $40 for a set.